England's Stove Works 25-PDVC Installation Instruction

IMPORTANT!  READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING 

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED. 

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR 

DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS. 

Always press the “OFF” touch pad before refueling. This unit has a 40-lb. hopper, and should be 

refilled when the hopper level drops to three or four inches.  

 

Note:  The hopper lid will be warm; therefore, you should always use some type of hand protection. 

NEVER place your hand near the auger while the stove is operating. 

 

Note:  Always ensure that all pellet matter is cleared from the hopper lid gasket before closing.  Be 

sure to close and latch hopper securely before re-firing.  Do not operate this unit with the 
hopper lid open or unsecured.

 

If the power to the unit is interrupted for approximately three minutes or less, the unit will resume 

operation when power is restored according to the following table: 

 

ON Start-Up 
Start-Up Start-Up 
Shut-Down Shut-Down 
OFF OFF 

 

If the power is interrupted for more than (approximately) three minutes, the unit will be “OFF” 

when power returns. 

 

the closest outside door and a window to eliminate the home’s natural draft.  Wait 
for power to be restored and then press the “ON” button to re-start the unit, if necessary. 

We highly recommend the use of a surge protector with your unit, as power surges and failures 

can affect the operation of any electrical appliance.   

We do not recommend leaving home with the stove on the higher heat ranges; it is 

recommended that the stove be left on the lower heat ranges (Heat Range setting 1 or 2). 

 

NOTE: Remember:  1) It is very important for the unit to be vented properly (see instructions on 

Outside Air), as the natural draft is needed to clear the smoke from the stove.  2)  Do not 
open the hopper lid (or the unit’s door).  This may cause fire to burn in the hopper.   

 

If the unit should run out of pellets, simply reload the hopper and press the “ON” button (only 

once) to re-start the unit.  If the unit runs without pellets, after one hour the unit will shut down.   
NOTE:  Even if flames are visible inside the fire box always press the “ON” button to ensure that 

your unit will restart. 

 

If the Combustion (exhaust) Blower should fail on this unit, a Vacuum Shut-Down Switch will 

automatically stop the stove.  This will shut your unit completely off, and there will be an “E-1” code in 
the Heat Range and Blower Speed windows on the Control Board.  At this point you will need to 
contact Technical Support at (800) 245-6489. 

 

NOTE: It is very important for the unit to be vented properly (see instructions on Outside Air), as the 

natural draft is needed to clear the smoke from the stove.