England's Stove Works 25-PDVC Installation Instruction

IMPORTANT!  READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING 

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED. 

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR 

DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS. 

The seals around the top of the pellet hopper are important to safe and efficient operation of the 

unit. The latches installed on these units are designed to pull the hopper lid tight against this seal. 
Over the course of operation as these seals “wear in” and compress, the tension of the latches 
should be tested periodically, and adjusted if necessary.  

To adjust the lid latches, the following tools will be needed; two ½ inch wrenches, or a ½ inch 

wrench and a ½ inch socket. 

In order to adjust the latch, first (with the unit unplugged and cooled down) open the hopper lid 

and then lock the latch in its closed position. Then take the ½ inch wrench and loosen the nut closest 
to the latch. This nut is then adjusted closer to the lid itself to tighten the latch. After adjusting this nut 
to the desired location, hold this nut in place with the ½ inch wrench, the tighten down the holding nut 
on the end of the latch shaft with the ½ inch socket or second wrench  to hold the latching assembly 
in place  

After tightening the latches, test the latches for proper tension by locking the lid down and lifting 

each front corner of the lid. The lid should be firmly held down by the latches. Repeat the same 
procedure if the latch is still not tight enough.