Brother TN-872A Owner's Manual
Programmer
177
Chapter 3 Programming with Command Function
3.
Input command depending on the feed.
Press
L
if not specified.
Creating split data
Command to be used
L
2
2
0
Stopping the needle at the upper end for the split.
L
2
2
1
Stopping the needle at the lower end for the split.
1.
Input command depending on the split.
Creating magnified data
Command to be used
M
9
0
2
Input for magnification (x2)
M
9
0
5
Input for magnification (x5)
M
9
1
0
Input for magnification (x10)
The following three scales are available for magnification: x2, x5, and x10.
Use a pattern sheet suitable for the magnified pattern.
The magnified data is reduced when the end code is input.
1.
Make sure that the needle is at the home position.
Press
R
if not specified.
2.
Select magnification and press
M
9
.