Brother NX-400 Owner's Manual
47
3
c
Select stitch
.
d
Position the fabric so that the opening of the
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
a 2 mm (1/16 inch)
Pass the upper thread down through the hole
in the presser foot.
• When lowering the presser foot, do not push
in the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
bar tack will not be sewn with the correct
size.
bar tack will not be sewn with the correct
size.
a Do not reduce the gap.
e
Pull down the buttonhole lever as far as
possible.
possible.
a Buttonhole lever
The buttonhole lever is positioned behind the
bracket on the buttonhole foot.
bracket on the buttonhole foot.
a Buttonhole lever
b Bracket
b Bracket
f
Gently hold the end of the upper thread in
your left hand, and then start sewing.
your left hand, and then start sewing.
X
Once sewing is completed, the
machine automatically sews
reinforcement stitches, then stops.
machine automatically sews
reinforcement stitches, then stops.
g
Raise the presser foot lever, remove the
fabric, and cut the thread.
fabric, and cut the thread.
h
Raise the buttonhole lever to its original
position.
position.
Memo
● If the fabric does not feed, for example,
because it is too thick, increase the stitch
length. For details, refer to “Selecting
stitching” (page 27).
length. For details, refer to “Selecting
stitching” (page 27).
1