Brother HL-2700CN Quick Setup Guide

3

U.S. Food and Drug Administration (FDA) has implemented regulations for 
laser products manufactured on and after August 2, 1976. Compliance is 
mandatory for products marketed in the United States. One of the following 
labels on the back of the printer indicates compliance with the FDA 
regulations and must be attached to laser products marketed in the United 
States.

☛

 Caution:

Use of controls, adjustments or performance of 
procedures other than those specified in this manual may 
result in hazardous radiation exposure. 

This printer is a Class 1 laser product as defined in IEC 60825 specifications. 
The label shown below is attached in countries where it is needed.

This printer has a Class 3B laser diode which produces invisible laser 
radiation in the scanner unit. You should not open the scanner unit under any 
circumstances. 

☛

 Caution:

Use of controls or adjustments or performance of 
procedures other than those specified in this User’s Guide 
may result in hazardous radiation exposure.

☛

 Varoitus! 

Laitteen käyttäminen muulla kuin tässä käyttöohjeessa 
mainitulla tavalla saattaa altistaa käyttäjän 
turvallisuusluokan 1 ylittävälle näkymättömälle 
lasersäteilylle. 

☛

 Varning 

Om apparaten används på annat sätt än i denna 
Bruksanvisning specificerats, kan användaren utsättas för 
osynlig laserstrålning, som överskrider gränsen för 
laserklass 1.

Maximum radiation power: 5 mW
Wave length:

780 - 800 nm

Laser class:

Class IIIb 
(Accordance with 21 CFR Part 1040.10)
Class 3B 
(Accordance with IEC 60825)

To ensure safe operation the supplied three-pin plug must be inserted only 
into a standard three-pin power outlet that is properly grounded through the 
normal household wiring. 

Extension cords used with this printer must be three-pin plug type and 
correctly wired to provide proper grounding. Incorrectly wired extension 
cords may cause personal injury and equipment damage. 

The fact that the equipment operates satisfactorily does not imply that the 
power is grounded and that the installation is completely safe. For your 
safety, if in any doubt about the effective grounding of the power, call a 
qualified electrician. 

You must install this printer near a power outlet that is easily accessible. In 
case of an emergency, you must disconnect the power cord from the power 
outlet to shut off the power completely.

Connect this product to a LAN connection that is not subjected to over 
voltages.

This product is also designed for an IT power system with phase-to-phase 
voltage 230V.

Lpa < 70 dB (A) DIN 45635-19-01-KL2

If you need to replace the plug fuse, fit a fuse that is approved by ASTA to 
BS1362 with the same rating as the original fuse.

Always replace the fuse cover. Never use a plug that does not have a cover.

The wires in the mains lead are coloured in line with the following code:

If in any doubt, call a qualified electrician.

MANUFACTURED:
Brother Industries, Ltd., 
15-1 Naeshiro-cho Mizuho-ku Nagoya, 467-8561 Japan
This product complies with FDA radiation performance standards, 21 
CFR subchapter J.

CLASS 1LASERP RODUCT
APPAREIL Å LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT