Enfora GSM2228UG001 User Manual
Regulatory Compliance
FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone
configuration, which demonstrated that the GSM2000 Mini-MT complies with Part
15 emission limits. FCC Part 22 & Part 24 is covered by the Enfora Enabler-IIG
"modular approval" process for a transmitter. This approach, described by FCC
Public Notice DA 00-131407 released June 26, 2000, is intended to afford relief
to equipment manufacturers by eliminating the requirement for obtaining a new
equipment authorization for the same transmitter when installed in a new device.
In order to use the GSM2000 MINIMT without additional FCC certification approvals, the installation must
meet the following conditions:
meet the following conditions:
For the transmitter to meet the MPE categorical exclusion requirements of
2.1091, the ERP must be less than 1.5 watts for personnel separation distance
of at least 20 cm (7.9 in). Therefore, the maximum antenna gain cannot exceed
+3.3dBi. If greater than 1.5 watts exists, then additional testing and FCC
approval is required.
2.1091, the ERP must be less than 1.5 watts for personnel separation distance
of at least 20 cm (7.9 in). Therefore, the maximum antenna gain cannot exceed
+3.3dBi. If greater than 1.5 watts exists, then additional testing and FCC
approval is required.
R&TTE -
The GSM2228 Mini-MT modem has been fully tested and complies with all the
requirements of EN301 489-1, EN301 489-7 and EN60950-1:2001. Compliance
to EN301 511 has been demonstrated by testing on both the GSM2000 and the
integrated GSM0108 module.
requirements of EN301 489-1, EN301 489-7 and EN60950-1:2001. Compliance
to EN301 511 has been demonstrated by testing on both the GSM2000 and the
integrated GSM0108 module.
Disclaimer
The information and instructions contained within this publication comply with all
FCC, GCF, PTCRB, R&TTE, IMEI and other applicable codes that are in effect at
the time of publication. Enfora disclaims all responsibility for any act or
omissions, or for breach of law, code or regulation, including local or state codes,
performed by a third party.
Enfora strongly recommends that all installations, hookups, transmissions, etc.,
be performed by persons who are experienced in the fields of radio frequency
technologies. Enfora acknowledges that the installation, setup and transmission
guidelines contained within this publication are guidelines, and that each
installation may have variables outside of the guidelines contained herein. Said
variables must be taken into consideration when installing or using the product,
and Enfora shall not be responsible for installations or transmissions that fall
outside of the parameters set forth in this publication.