Bowflex TreadClimber TC1000 User Manual

Bowflex

TreadClimber

Owner’s Manual

Assembly Guide

Figure 1-3

Figure 1-5

Figure 1-1

#!,,

ALIGN TO TREADLES

ALIGN TO UPRIGHT
BRACKET

FF2899

#!,,

0/52

ALIGN TO TREADLES

ALIGN TO UPRIGHT
BRACKET

FF2899

TREADLES

BRACKET

#!,,

ALIGN TO TREADLES

ALIGN TO UPRIGHT
BRACKET

FF2899

Remove before use and follow these directions, “Before
tightening the bolts on the rear casting, center the treadles
using this card as a guide.”
Retirez avant l'emploi et suivez les ces directions, “Avant
serrant les boulon sur le bâti arrière, centrez les pédales en
utilisant cette carte comme guide.”

Illustration 1-A

Figure 1-2

Assembly Instructions

Step 1: PLACING TREADLES ON BASE

Locate the following for this step:

PARTS:

• TreadClimber

Base Assembly

• TreadClimber

Treadle Assembly

HARDWARE:

• Four (4) 3/8” x 1-1/4” Hex Bolts

TOOLS:

• 9/16” Open End Wrench (included)

• Scissors or other cutting tool

1-1 Place the latch lever on the base in the unlocked

position (see Figure 1-1).

1-2 Cut the wire ties on the teeter assembly and

extend the teeter to the center of the treadles

(see Figure 1-2).

1-3 With the help of another, carefully rotate the

treadle assembly so the teeter is hanging

downward above the base. Slowly lower

treadle assembly onto base. Make sure teeter

mechanism passes freely through hole in the

center of base (see Figure 1-3). Carefully

align roller casting so it lays flush on the base

(see Figure 1-4). For TC3000 and TC5000

models verify that the step sensor is properly

aligned (see Figure 1-3). For all TreadClimber

machines center the treadles, using the orange

treadle alignment card (see Illustration 1-A),

before proceeding.

1-4 Using the 9/16" open end wrench, tighten the

(4) 3/8" x 1-1/4" hex bolts on the rear roller

casting to bring the casting and base snugly

together (see Figure 1-5).

Figure 1-4

Align roller casting so it lays

flush on base