Bowflex TreadClimber TC1000 User Manual

Bowflex

TreadClimber

Owner’s Manual

Step 19: CALIBRATION PROCESS (TC3000 and TC5000 only)

Assembly Guide

failure to calibrate your machine prior to use could result in machine failure

and could cause injury.
during the entire calibration process, stand on the side foot support platforms or rubber

mat only, do not stand on the walking belts!

7 ! 2 . ) . '

! 4 4 % . 4 ) / .

$ ! . ' % 2

DO NOT STEP ON THE BELTS DURING

THIS ENTIRE PROCESS.

Owners of the TC3000 or TC5000 will need to

calibrate the TreadClimber

machine before they

can begin exercising. Owners of the TC1000 do not

need to complete this step.

Calibrating the TC3000 and TC5000 is an important

part of troubleshooting maintenance.

NOTE: You will also need to re-calibrate

your machine in the event of

a power outage or if you have

replaced a TreadClimber

component, such as a belt, or

motor.

19-1 Plug power cord into wall outlet.
19-2 Turn on Main Power Switch (see Figure 19-1).
19-3 Stand on the side foot support platforms or

rubber floor mat, DO NOT STAND ON THE

BELTS.

19-4 Insert the Safety Key, press and hold down the

POWER button, then very quickly press and

hold down the SLOWER button. Continue to

hold down the POWER and SLOWER buttons

(see Figure 19-2 for the TC5000 and Figure

19-3 for the TC3000).

NOTE: If the Safety Key is not fully

inserted into the safety keyhole, the

TreadClimber

machine will NOT

power up.

19-5 At this point you should see the numbers start

to decrease on the console.

19-6 While continuing to hold down the POWER

and SLOWER buttons, remove and re-insert

the Safety Key.

Figure 19-1

Main Power Switch “On”

Figure 19-2

TC5000 Power & Slower Buttons

0/7%2

*"7 ,

Figure 19-3

TC3000 Power & Slower Buttons