Bosch DKE94 User Manual
English 7
CAUTION: Be careful not to scratch chimney surface when connecting. Slide tem-
plates between the two chimney sections to protect them.
plates between the two chimney sections to protect them.
Insert bottom edge of chimney into top of hood. Slide upper section up until it is
flush with the surface above. Attach to chimney mounting bracket with two sheet
metal screws.
flush with the surface above. Attach to chimney mounting bracket with two sheet
metal screws.
9) Final Steps
Remove templates from between chimney sections if necessary. Remove protec-
tive film from hood. Install grease filters (See Use and Care Manual).
tive film from hood. Install grease filters (See Use and Care Manual).
Test the installation.
Note: Be sure to check for backdraft. With the blower on high, close the windows
and doors to the area to ensure that fan does not cause back drafting in any outlet
vent for another appliance.
and doors to the area to ensure that fan does not cause back drafting in any outlet
vent for another appliance.
Before Calling
Service
Service
See Use and Care Manual for troubleshooting information. Refer to the Warranty
in the Use and Care Manual. Please be prepared with the information printed on
your product data plate when calling.
in the Use and Care Manual. Please be prepared with the information printed on
your product data plate when calling.
Product Data Plate
The data plate shows the model and serial number. It is located below the filter.
Figure 7:
Install Chimney
1.
2.
3.
Service