Bosch HWD2750UC Quick Setup Guide

English 6

4.

Install warming drawer.

It is recommended to have 2 installers to install warming drawer. Failure 
to do so may result in property damage or personal injury.

Slide warming drawer assembly into cutout until it is flush with cabinet. Secure 
through four screw holes in front frame (drill pilot holes in cabinet first if 
necessary).

5.

Attach custom drawer front (optional).

Use care when handling glass panel to avoid breaking. Broken glass 
could cause injury.

1) Prepare custom drawer front as explained above.

2) Remove drawer from warming drawer frame (See Use and Care Manual for 

instructions).

3) Remove six screws from backside of drawer front. Set handle and screws 

aside.

4) Remove signal light lens from glass panel and set aside. Discard glass 

panel (Note: stainless  steel models do not have a glass panel).

5) Install the signal light lens in the custom drawer front.

6) Attach drawer front with six screws. Attach handle as well if desired. 

6.

Replace drawer.

1) Be sure cabinet rails are pushed inside cabinet.

2) Align the drawer rails with the cabinet rails.

3) Firmly push the drawer straight into the cabinet until drawer clicks into 

place.

4) Open and close drawer to test operation. Note: if the drawer will not close, 

verify that the rail clips are properly positioned.

7.

Turn power on at the service panel.

8.

Test the installation.

Turn the warming drawer on. Signal light and timer should turn on immediately. 
Check for warmth.