White Rodgers 1F95-80 User Manual
5
Before you begin programming your thermo-
stat, you should be familiar with its features and
with the display and the location and operation
of the thermostat buttons. The information in
this section will help you become familiar with
your new thermostat so that you can easily
program it.
stat, you should be familiar with its features and
with the display and the location and operation
of the thermostat buttons. The information in
this section will help you become familiar with
your new thermostat so that you can easily
program it.
Your thermostat consists of two parts: the ther-
mostat body and the subbase.
mostat body and the subbase.
Use
SYSTEM
SWITCH
to turn thermostat to OFF
mode before removing or attaching the
thermostat body. Failure to do so may
result in equipment damage and/or per-
sonal injury.
thermostat body. Failure to do so may
result in equipment damage and/or per-
sonal injury.
OPERATING YOUR THERMOSTAT
The subbase is attached to the wall, but you
can remove the thermostat body for easy pro-
gramming. To remove the thermostat body
from the subbase, grasp the thermostat body
and gently pull it straight out from the subbase.
To attach the thermostat body, line up the four
terminal pins on the upper section of the ther-
mostat back with the matching connector on
the subbase. Insert these, then gently pivot the
thermostat body down to connect the eight pin
connectors on the lower portion of the thermo-
stat back. Gently push until the snap connec-
tors engage. DO NOT FORCE OR PRY THE
THERMOSTAT as this may damage the unit.
can remove the thermostat body for easy pro-
gramming. To remove the thermostat body
from the subbase, grasp the thermostat body
and gently pull it straight out from the subbase.
To attach the thermostat body, line up the four
terminal pins on the upper section of the ther-
mostat back with the matching connector on
the subbase. Insert these, then gently pivot the
thermostat body down to connect the eight pin
connectors on the lower portion of the thermo-
stat back. Gently push until the snap connec-
tors engage. DO NOT FORCE OR PRY THE
THERMOSTAT as this may damage the unit.
CAUTION
!