Brother FAX 580MC Owner's Manual
M E S S A G E C E N T E R
9 - 8
Remote Retrieval
Using Remote Access Code
1
Dial your fax number from a touch tone phone.
2
When your FAX/MFC answers, immediately enter your Remote Retrieval Access
Code.
Code.
3
The FAX/MFC signals the kinds of messages received:
1 long beep—Fax message(s)
2 long beeps—Voice message(s)
3 long beeps—Fax and Voice message(s)
No beeps—No messages
4
The FAX/MFC then prompts you with two short beeps to enter a command. If you
wait longer than 30 seconds to enter a command, the MFC hangs up. If you enter an
invalid command, the FAX/MFC beeps three times.
wait longer than 30 seconds to enter a command, the MFC hangs up. If you enter an
invalid command, the FAX/MFC beeps three times.
5
Press
9 0
to reset the FAX/MFC when you finish.
6
Hang up.
Changing Remote Retrieval Access Code
Enter your Remote Retrieval Access Code when the FAX/MFC picks up your call, so
you can access features remotely. The access code is preset to 159
you can access features remotely. The access code is preset to 159
, but you can
change it.
1
Press
Function/Set
,
8
,
7
.
2
Enter a three-digit number from 000 to 999 and press
Function/Set
. The “
” cannot
be changed.
3
Press
Stop
to exit.
If your FAX/MFC is set to MANUAL mode, you can access the Message Center by
waiting about 2 minutes, then entering the Remote Access Code within 30 seconds.
waiting about 2 minutes, then entering the Remote Access Code within 30 seconds.
Do not use the same digits that appear in your Fax Receive Code or Telephone
Answer Code.
Answer Code.