Brother XM3700 Owner's Manual

the right side (see arrow b) until the cover
clicks into place.

• Replace the cover so that the end of the

thread comes out from the left side of the
cover (as shown by the line in the diagram).

■ For models equipped with the quick-set bobbin

Raise the needle to its highest position by turning
the handwheel toward you (counterclockwise) or
press

(needle position button) (for models

equipped with the needle position button), and
raise the presser foot lever.

Slide the button and open the cover.

a Cover
b Slide button

Put the bobbin in, feed the end of the thread
through the slit, and then pull the thread to cut it.

• Only use bobbins that were designed to be

used with this machine.

a Cutter

• Make sure that the thread is correctly

inserted through the tension-adjusting spring
of the bobbin case. If it is not inserted, re-
insert the thread.

a Tension-adjusting spring

Memo

● The order that the bobbin thread should be

passed through the bobbin case is indicated
by marks around the bobbin case. Be sure
to thread the machine as indicated.

Replace the bobbin cover. Put the left tab in
place (see arrow a), and then press lightly on
the right side (see arrow b) until the cover
clicks into place.

Memo

● You can begin sewing immediately without

drawing up the bobbin thread. If you want
to draw up the bobbin thread before you
start to sew, follow to the procedure in
“Drawing up the lower thread” (page 19).

● Make sure you set the bobbin so the thread

unrolls in the right direction. If the thread unrolls
in the wrong direction, it may cause the thread
tension to be incorrect or break the needle.

CAUTION

NCBC2000.book Page 15 Thursday, October 21, 2004 4:32 PM