Woodstock System W1827 User Manual

-18-

Kn`jk9lkkfe:cfZbn`j\

KfI\j\kJn`kZ_%%%

=`^li\(0% Resetting the emergency stop 

switch.

Once the assembly is complete, test run your machine 
to make sure it runs properly and is ready for regular 
operation. 

The test run consists of verifying the following: 1) The 
motor powers up and runs correctly, and 2) the safety 
feature on the emergency STOP button works correctly.

If, during the test run, you cannot easily locate the source 
of an unusual noise or vibration, stop using the machine 
immediately, then review 

KiflYc\j_ffk`e^ on GX^\+*. 

If you still cannot remedy a problem, contact our Tech 
Support at (360) 734-3482 for assistance.

(%  Make sure you understand the safety instructions 

at the beginning of the manual, and verify that the 
machine is setup properly.

)%  Ensure all tools and objects used during setup are 

cleared away from the machine.

*%  Connect the machine to the power source.

+%  Push the ON button (see =`^li\(/) to enable power 

to the motor—the power source lamp should light.

,%  Push the emergency STOP switch, then twist it 

clockwise so it pops out. When the switch pops out it 
is reset and ready for operation (see 

=`^li\(0).

-%  Turn the FWD/REV switch to the right to verify the 

machine operates correctly.

— When operating correctly, the machine runs 

smoothly with little or no vibration or rubbing 
noises.

— Investigate and correct strange or unusual noises 

or vibrations before operating the machine further. 
Always disconnect the machine from power when 
investigating or correcting potential problems.

.%  Turn the FWD/REV switch to the OFF (middle) 

position and press the emergency STOP switch to 
turn the machine 

F==.

=`^li\(/% Control panel.

/% WITHOUT 

resetting 

the 

emergency 

STOP switch, turn the FWD/REV switch 
to the right in an attempt to start the 
machine. The machine should 

EFK 

start.

— If the machine 

;F<J start (with the 

emergency STOP button pushed in), 
immediately disconnect power to 
the machine. The emergency STOP 
switch safety feature is not working 
correctly. This safety feature must 
work properly before proceeding 
with regular operations. Call Tech 
Support for help.