Woodstock System W1827 User Manual

-29-

Because the shaper fence boards are independently 
adjustable, you can set up the shaper to cut part or all of 
the workpiece edge.

(% Loosen the infeed fence bracket lock handle that 

secures it to the guard body. 

)%  Turn the fence adjuster handwheel located on the 

back of the fence bracket and adjust the infeed 
fence until the workpiece contacts the cutter at the 
desired location, then re-tighten the lock handles.

*%  Adjust the outfeed fence even with the infeed 

fence.

+%  Set both fence boards as close to the cutter from 

side-to-side as possible without interfering with the 
cutter rotation. Make sure that the fence boards are 
firmly secured to the brackets and that all knobs and 
locks are tight.

,% Turn 

the 

shaper 

FE. 

-%  Using a piece of scrap wood, advance the workpiece 

just past the edge of the outfeed fence, and turn 
the machine 

F==. DO NOT remove the workpiece 

from the infeed fence face. 

.%  Once the cutter has come to a complete stop, adjust 

the outfeed fence so that it just touches the newly 
cut edge as shown in 

=`^li\*0% 

/%  Tighten the outfeed fence bracket lock handle.

(%  Loosen the infeed fence bracket lock handle that 

secures it to the guard body.

)%  Turn the fence adjuster handwheel and adjust the 

infeed fence until the workpiece contacts the cutter 
at the desired location, then re-tighten the lock 
handle.

*% Align the outfeed fence with the infeed fence as 

shown in 

=`^li\*0% Fence setup for jointing-type 

operations (Guard Not Shown for Clarity).

<e[M`\n

=`^li\+'%Fence setup for partial-edge 

removal (Guard Removed for Clarity).

<e[M`\n