Woodstock SHOP FOX W1701 User Manual
-12-
W1701 1HP Shaper
O
PE
R
AT
IO
N
S
OPERATIONS
General
DO NOT investigate problems or adjust
the Machine Name while it is running.
Wait until the machine is turned OFF,
unplugged and all working parts
have come to a complete stop before
proceeding!
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed incor-
rectly.
The instructions in this section are written with the under-
standing that the operator has the necessary knowledge
and skills to operate this machine.
If at any time you
are experiencing difficulties performing any operation,
stop using the machine!
If you are an inexperienced operator, we strongly recom-
mend that you read books, trade articles, or seek train-
ing from an experienced operator before performing any
unfamiliar operations.
Above all, your safety should
come first!
Always wear safety glasses when oper-
ating this machine. Failure to comply
may result in serious personal injury.
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Cutters vs. Router Bits
When shipped, the Model W1701 is setup for using shaper
cutters. However, if you plan on using router bits, you
must first convert the Model W1701 to a router table. To
convert your shaper to a router table, refer to
Page 23.
If you're not sure which type of cutting equipment you will
use, read below for the pros and cons of both.
Shaper Cutters
Pros—Shaper cutters are larger, more durable and gener-
ally last longer than router bits. If you plan on cutting
many linear feet of a certain profile, then shaper cutters
are the best choice.
Cons—Shaper cutters are much more expensive than rout-
er bits and they are typically too large for small projects.
Router Bits
Pros—Router bits are cheaper than shaper cutters and
come in a wider range of profiles and sizes. If you plan
on making small projects that do not require many linear
feet of cutting, then router bits are the best choice.
Cons—Router bits are not as durable as shaper cutters,
and they are typically designed to be operated faster
than this machine can operate.