Wayne-Dalton 255081 Leaflet
ADJUSTING THE CENTER BRACKET
INSTALLING CENTER BRACKET
Step 3
Standing inside the building looking out, lay the spring tube assembly
on the floor in front of the door with the red winding shaft to the left.
Align the cams of the spring tube assembly and the adjustable center
bracket/bushing assembly. Slide the adjustable center bracket/bush-
ing assembly onto the center of the spring tube. (Figure 3).
on the floor in front of the door with the red winding shaft to the left.
Align the cams of the spring tube assembly and the adjustable center
bracket/bushing assembly. Slide the adjustable center bracket/bush-
ing assembly onto the center of the spring tube. (Figure 3).
Figure 3
Figure 4
Figure 5
INSTALLING TORqUEMASTER
™
END BRACKETS
Step 5
Slide the TorqueMaster
™
end bracket over the drive gear and fasten to
the end bracket extension using a #10 self tapping screw. Now secure
the end bracket to the end bracket extension using (2) 1/4 - 14 x 5/8”
self tapping screws (Figure 5).
the end bracket to the end bracket extension using (2) 1/4 - 14 x 5/8”
self tapping screws (Figure 5).
IMPORTANT! DO NOT USE SUPPLiED 5/16” x 1-5/8” LAg SCREWS TO
ATTACH THE END BRACkET TO THE END BRACkET ExTENSiONS.
ATTACH THE END BRACkET TO THE END BRACkET ExTENSiONS.
Step 4
Attach the center bracket extension to the header using supplied (2)
5/16 x 1-5/8” lag screws as described in the installation instructions.
Locate the adjustable center bracket so that the TorqueMaster
5/16 x 1-5/8” lag screws as described in the installation instructions.
Locate the adjustable center bracket so that the TorqueMaster
™
tube
assembly is parallel to the door header (Figure 4). Fully tighten the
1/4 - 20 x 9/16” track bolts and hex nuts.
1/4 - 20 x 9/16” track bolts and hex nuts.
2