Sony Water Dispenser 2 User Manual

   Chapt

er

 12
 

Ex
te

rn

al De

v

ic

e

s

104

Control of VTRs and Disk Recorders

Set the start point as a timecode value.

Press [Enter].

The new start point setting is reflected in the status area.

To set the stop point, in the <Stop TC> group press the [Set] button.

A timecode window appears.

Set the stop point as a timecode value.

If you do not want to set the stop point, skip to step 

.

Press [Enter].

The new stop point setting is reflected in the status area.

To set the variable speed, in the <Variable Speed> group, carry out any of 

the following.

• Press [Fit].

Without setting a speed value, this automatically carries out playback 
according to automatically calculated values for the duration and 
keyframe duration to fit the set start point and stop point.

• Press the [Set] button, and adjust the parameter with the knob. 

a) The setting range of the variable speed depends on the type of connected device.

The new variable speed setting is reflected in the status area.

Repeat steps 

 to 

 as required for other devices.

With the following buttons in the device control block, you can set the start 
point or stop point of a keyframe point on the VTR/disk recorder timeline, or 
carry out a cueing up operation.

Check that the [MENU] button in the device control block is lit green. If it is 
not lit, press it, turning it on.

[START TC] button: Set the start point of the keyframe point to the current 

time.

2

Variable

Variable speed

–100 to +200 

a)