Sony Water Dispenser 2 User Manual
167
Snapshot Operations in the Flexi Pad Control Block
Chapt
er
1
4
Sna
p
s
hot
s
Not lit: Register not containing anything
4
To apply an attribute, hold down the [SNAPSHOT] button, and in the
memory recall section, press a button as follows, turning it on.
memory recall section, press a button as follows, turning it on.
For details of attributes and available attributes, see “Snapshot
Attributes” in Chapter 1 (Volume 1).
Attributes” in Chapter 1 (Volume 1).
Note
In the Flexi Pad control block, it is not possible to apply the cross-point
hold or GPI output attributes. In a simple type Flexi Pad control block, it
is not possible to apply any attributes. To add these attributes, use a menu
operation. (See page 170.)
hold or GPI output attributes. In a simple type Flexi Pad control block, it
is not possible to apply any attributes. To add these attributes, use a menu
operation. (See page 170.)
5
Still holding down the [SNAPSHOT] button from step
4
, press the
memory recall button corresponding to the register in which you want to
save.
save.
Note
If you press a button which is lit orange or yellow, the existing register
contents are overwritten.
contents are overwritten.
The button you pressed lights yellow, and this completes the save
operation. The [STORE STATS] button lights amber, and the numeric
display shows the selected register number after the bank number.
operation. The [STORE STATS] button lights amber, and the numeric
display shows the selected register number after the bank number.
To cancel a snapshot save operation
After saving a snapshot, to cancel the save, hold down the [STORE STATS]
button and press the [UNDO] button.
The [STORE STATS] button changes color from amber to green.
button and press the [UNDO] button.
The [STORE STATS] button changes color from amber to green.
Note
On a simple type Flexi Pad control block, it is not possible to cancel a snapshot
save operation.
save operation.
Recalling a snapshot from a Flexi Pad control block
As an example, to recall a snapshot on the M/E-1 bank, use the following
procedure.
procedure.
Attribute to apply
Button
Effect dissolve
[EFF DISS] button
Auto transition
[AUTO TRANS] button