Sony Water Dispenser 2 User Manual

183

Shotbox Register Creation

Cha

r 15

Ut
ilit
y/

hot

bo
x

To change the contents of a shotbox register

After recalling the shotbox register you want to change, referring to the
previous item “Creating a shotbox register,” change the contents of the
shotbox register, and save.

To check the region saved in a shotbox register

During operations to change the contents of a shotbox register, to check which
region is saved in the register, use the following procedure.

With the [SHOTBOX] button lit, press the [STORE] button, turning it on.

Press the required button, as follows, turning it on.

To check the snapshot region: [SNAPSHOT] button
To check the effect region: [EFF] button

Hold down the [STORE] button.

While this button is held down, the button for the saved region lights.
Releasing the button returns you to the state before holding down the
[STORE] button.

Note

While the [STORE] button is lit, the mode selection buttons ([TRANS RATE]
button and so on) in the numeric keypad control block do not operate. To
change the mode, press the [RCALL] button or [SHOTBOX] button so that the
[STORE] button goes off.

Creating a Shotbox Register Using the Menus

Accessing the Shotbox menu

Carry out creation and editing of shotbox registers in the Shotbox menu.
To access the Shotbox menu, use any of the following methods.
• In the menu control block, press the top menu selection button [SHOTBOX].
• In the numeric keypad control block, press the [SHOTBOX] button twice in