Sony Water Dispenser 2 User Manual

197

Setup for the Whole System

  

Ch
apt

er 16 

E

ngin

eering Se

tup

Select the switcher to be controlled by the selected control panel, as 
follows.

• If there is only one switcher on the network, in the <1st Switcher> 

group, set [SWR1] to ON, and in the <2nd Switcher> group, set [SWR2] 
to OFF.

• If there are two switchers on the same network, in the <1st Switcher> 

group, select the switcher to be operated.
When the system operation mode (see previous item) is set to [Dual 
Simul], the switcher status set in <1st Switcher> appears on the control 
panel.

To set the selected control panel as tally control master panel, press [Tally 
Master], turning it on.

If there are multiple panels and processors, the control panel for which 
[Tally Master] is set to ON carries out tally control for the whole system.

When there are multiple control panels, make sure that one of them has 
[Tally Master] set to ON. When you change the master panel, be sure to 
copy and save the setup tally (TLY) and router (RTR) data in the File 
menu, and make the same settings for other panels.

Use the following procedure.

In the System>System Config menu, press [Switcher Assign].

The Switcher Assign menu appears.

Using either of the following methods, select the switcher to which the 
settings apply.

• In the list appearing in the menu, press the desired device name.
• Press the arrow keys to scroll the reverse video cursor.

The selected switcher appears in reverse video.
If there is only one switcher on the network, carry out the SWR1 setting 
(for the first switcher) only.

Make the DME settings as follows.

• When making DME settings for SWR1 (the first switcher), for the 

first DME, select [DME1] in the <1st DME> group. Turn all buttons in 
the <2nd DME> group off.