Sony Water Dispenser 2 User Manual

223

Setup Relating to Operations From the Control Panel

  

Ch
apt

er 16 

E

ngin

eering Se

tup

Use the following procedure.

In the Panel>Device Interface menu, press [GPI Input].

The GPI Input menu appears.

Using any of the following methods, select the settings.

• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.

In the <Trigger Type> group, select the trigger type.

: Apply the trigger on a rising edge of an input pulse.

: Apply the trigger on a falling edge of an input pulse.

: Apply the trigger on a change in the polarity of the input signal.

 (Level): Carry out the specified operation when the input is low or 

high.

No Operation: Apply no trigger on an input pulse.

In the <Target> group, select the action block.

M/E-1, M/E-2, M/E-3, P/P: Set the action for one of the operating banks.
Common/Setup: Set an action for something other than the above, or a 

setup action.

Using any of the following methods, select the action to be set.

• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.

a) • Action list when the trigger type is other than “Level”

1

Port

Port selection

1 to 8

2

Action

Action selection

1 to ... 

a)

5

Reg No

Register number

1 to 4 

b)

1 to 99 

c)

1 to 399 

d)