Sony Water Dispenser 2 User Manual

  

 Chapt

er

 16

 

Eng

inee

ring
 S
e

tu

p

254

Setup Relating to Switcher Processor

Select the device interface you want to set for the REMOTE3 port from the 
<Remote3> group.

Editor A: assign Editor A to the REMOTE3 port.
Editor B: assign Editor B to the REMOTE3 port.
AUX: assign AUX to the REMOTE3 port.
DME1: assign DME1 to the REMOTE3 port.

When REMOTE3 and REMOTE4 are respectively assigned to DME1 and 
DME2, you can switch the AUX bus from the DME (DME-3000/7000) 
connected to these ports.
At this time, connect the DME input video signals and key signals as 
follows.
• DME1 video input: AUX1 output
• DME1 key input: AUX2 output
• DME2 video input: AUX4 output
• DME2 key input: AUX5 output
Note that for a DME external video signal, you can select any of AUX1 to 
AUX14 on the DME. Connect to the selected AUX bus.

Use the following procedure.

In the Switcher>Device Interface menu, press [GPI Input].

The GPI Input menu appears.

Using any of the following methods, select the settings.

• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.

In the <Trigger Type> group, select the trigger type.

: Apply the trigger on a rising edge of an input pulse.

: Apply the trigger on a falling edge of an input pulse.

: Apply the trigger on a change in the polarity of the input signal.

1

Port

Port selection

1 to 8

2

No

Selection of number for action to be 
assigned

1 to 8