Sony Water Dispenser 2 User Manual
Chapt
er
16
Eng
inee
ring
S
e
S
e
tu
p
276
Setup Relating to DCU
7
Set the VTR constants using values in the range 00 to ff.
8
Press [Enter].
This confirms the settings.
9
Repeat steps
5
to
8
as required to set the constants for other VTRs.
To make detailed settings for a disk recorder (Sony disk 9-pin
protocol)
protocol)
Use the following procedure.
1
In the DCU>Serial Port Assign menu, select the target for the setting
(DCU1 or DCU2) from the <DCU Select> group.
(DCU1 or DCU2) from the <DCU Select> group.
2
Using any of the following methods, specify the serial port connected to
the disk recorder for which you want to make the settings.
the disk recorder for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.
Block
Byte
Setting item
BLOCK 1
1
HI-BYTE (DEVICE TYPE)
2
LO-BYTE (DEVICE TYPE)
3
HI-BYTE (FRAME) (PREROLL TIME)
4
LO-BYTE (FRAME) (PREROLL TIME)
5
EDIT DELAY (FRAME)
6
EE DELAY (FRAME)
7
OVER RUN (FRAME)
8
TRAJECTORY
BLOCK 2
1
TC READ DELAY (FRAME)
2
START DELAY (FRAME)
3
AFTER SYNC DELAY–
4
AFTER SYNC DELAY+
5
MODE1
6
MODE2
7
MAX PRRL SPEED
8
QUICK PVW PRRL TIME (FRAME)
Knob Parameter
Adjustment
Setting
values
1
Port No
Serial port
1 to 30