Sony Water Dispenser 2 User Manual
Chapt
er
12
Ex
te
te
rn
al De
v
ic
e
s
92
Control of GPI Devices
• Turn the knob to make the selection.
a) 1: Off (no specification)
2: Control panel (SCU) GPI port
3: DCU GPI port
3: DCU GPI port
4
If in step
3
you selected 2 (SCU) or 3 (DCU), then use the knob to select
the port number.
The indication for knob 3 depends on whether SCU or DCU is selected.
a) The number of DCU GPI ports depends on the settings in Engineering Setup.
The setting is reflected in the list on the right of the status area.
5
Press [Set].
This specifies the SCU/DCU GPI port whose number you specified in step
4
as the pulse output destination for the GPI output port selected in the list
on the left of the status area.
Repeat steps
1
to
5
for other GPI output ports as required.
Testing trigger output
To test the trigger output, press [Test Fire].
According to the list settings on the left of the status area, a pulse is output from
the selected output port.
According to the list settings on the left of the status area, a pulse is output from
the selected output port.
Clearing output port settings
To clear the settings for each device (GPI output port)
Use the following procedure.
1
In the list on the left of the status area, select the GPI output port whose
settings you want to clear.
settings you want to clear.
Knob
Parameter
Setting
Setting values
2
GPI Port No
SCU/DCU GPI port to be the
trigger output destination
trigger output destination
1 to 3
a)
Knob
Parameter
Setting
Setting values
3
SCU Port No
SCU GPI port number
1 to 8
3
DCU Port No
DCU GPI port number
1 to 50
a)