Sony ICF-SC1 User Manual

Programmable Scanning

Programmable Scanning scans a frequency range you

have defined step by step. You can also specify the
frequency step and the detection mode.

Defining the frequency range

Define the range by specifying the lower and the upper
limits of the range. The preset channels for the upper and

lower limits are located after channel 30 of page 10. You

cannot use any other channel for this purpose.

3
4

5

6

1   Set the SQL control to MIN.

2    Press POWER to turn the receiver on.

Tune in, by any way, to a frequency to be specified as

the lower limit of the range.
Adjust the frequency step and the detection mode.
Press STEP repeatedly to select a frequency step of

your choice.
Press MODE repeatedly to select a detection mode of

your choice (see “Adjusting frequency step and

detection mode”, page 31).

Skip this step to select the default step and detection
mode.
While holding down ENTER, press  “10/0”,  then EXE.
“PRESET” and the preset number will flash in the

display. (Do not release ENTER).
While holding down ENTER, press  + or - repeatedly
until “PRESET L” appears for the preset number

display.

With each press, the preset number display will

change as follows.

“L” (“Lower limit”) comes after preset channel 30.

(Do not release ENTER).

7 While holding down ENTER, press EXE again.

The lower limit frequency has been memorized in
preset L.

8 Repeat steps 3 to 7 to memorize the upper limit

frequency in preset  U.  “U” (“Upper limit”) comes

after preset L.
Select the same frequency step and detection mode as

you did for the lower limit frequency.

*You can specify either 

frequency first.

*If 

you have selected a different frequency step or detection mode

for the upper and lower limits, the  one(s) memorized 

later will

take precedence.

*The delay setting is 

not saved for preset channel L or U.