Rolls MX902 User Manual
+6
+50
MIC 1
MIC 2
MIC 3
LINE 1
-6 dB
LINE 2
-6 dB
LINE 3
-6 dB
5/RIGHT
7/RIGHT
9/RIGHT
4/LEFT/MONO
6/LEFT/MONO
8/LEFT/MONO
AUX 1
SEND
AUX 2
SEND
LEFT OUT
RIGHT OUT
AUX 1
RET LEFT/MONO
AUX 1
RET RIGHT
PHANTOM
PWR
dB
+6
+50
dB
+6
+50
dB
to Effects Input
from
Right Output
from
Left Output
STEREO EFFECTS DEVICE
SIGNAL PROCESSOR CONNECTION
Use Aux 1 Output to connect to the Input of your signal processor which may be an echo unit, a
reverb, or multi effects unit. Aux 1 is used because the signal is taken after the channel fader
which is a typical setup for a signal processor. The right and left outputs of the processor are then
connected to the Aux 1 Right and Left Return jacks. The level of signal going into the signal pro-
cessor is controlled by the Aux 1 control on each individual MX902 channel, and the signal
processor’s input level control. The level of signal going back into the MX902 is controlled by Aux 1
Return Level control on the MX902 front panel, and by the signal processor’s output level control.
Use Aux 1 Output to connect to the Input of your signal processor which may be an echo unit, a
reverb, or multi effects unit. Aux 1 is used because the signal is taken after the channel fader
which is a typical setup for a signal processor. The right and left outputs of the processor are then
connected to the Aux 1 Right and Left Return jacks. The level of signal going into the signal pro-
cessor is controlled by the Aux 1 control on each individual MX902 channel, and the signal
processor’s input level control. The level of signal going back into the MX902 is controlled by Aux 1
Return Level control on the MX902 front panel, and by the signal processor’s output level control.
4