Roland BR-600 User Manual

Page of 228
 
59
 
Repeating Playback (Repeat)
Re
v0.10
 
Section 1
 
Normally, the repeat start and end points are registered at 
the exact position where [REPEAT] is pressed. This may 
make it difficult for you to set the repeat portion exactly as 
you desire. 
If this is the case, you can use the quantize function to have 
the time [REPEAT] is pressed be adjusted to the timing of 
the song. The quantize function allows you to set the timing 
in one-measure units.
Perform the procedure given below to use the quantize 
function.
 
1
 
Confirm that [PAD] is not lit, then press [UTILITY].
 
2
 
Press CURSOR [
] [
] to move the cursor to 
“SYS,” and press [ENTER].
 
fig.01-150
 
3
 
Press CURSOR [
] [
] to select “AB Qtz,” and 
turn the TIME/VALUE dial to turn the setting on.
 
When off, the quantize function will not work.
 
fig.01-160
 
4
 
Press [UTILITY] (or press [EXIT] repeatedly) to return 
to the Play screen.
 
* During updating, “Keep power on!” appears in the upper 
line of the display, while the lower line shows what is being 
processed.
 
Setting the Repeat Portion 
with Accurate Timing
Changing the tempo after having made the quantize 
function settings in a repeated portion will result in 
timing discrepancies between the repeat start and end 
points and the beginnings and ends of measures.
• You can set the repeat portion to one measure by 
pressing [REPEAT] twice at the same position.
• When the repeat portion is set, you can use the 
following functions to edit your recorded track 
data.
Before using these functions, you can use the 
quantize function to set the repeat portion with 
accurate timing.
BR600_e2 59 ページ 2006年4月17日 月曜日 午前9時3分