Rane Music Mixer FPG 45 Leaflet

FPG 45

CROSSFADER

Service Instructions for Penny & Giles X3000 Series Crossfader

Introduction
Servicing is limited to cleaning, re-lubrication and replacement of some components, such as the slider and track assembly. Periodic

maintenance provides a smooth operating feel and extends the life of the fader. Cleaning of the fader is necessary if it is used in dirty

or dusty environments or if contaminants have reached inside. The fader must be removed from the panel before servicing.

Spare Part
Description

Penny & Giles Part No.

Rane Part Number

PGFX3000

D460621

12206 (shown right)

Instructions
1. Remove the two screws from the end of the fader where the

wires exit, and pull away the end block. Withdraw the dust

cover and damping washer. Taking great care remove the

slider assembly, ensuring the wiper contacts are not damaged

as this affects operation. Cleaning of the slider assembly is

possible by gently wiping the wiper contacts and slider bear-

ings using a tissue or cotton bud. If the slider bearings are

excessively worn, as seen by excessive slider rocking, a replace-

ment assembly should be fitted.

2. Clean the guide rod, using a tissue or cloth, removing all

traces of dirt or contamination.

3. Remove the track by carefully withdrawing from the unit and

placing face up on the desk. It may be cleaned with a lint free

cloth, rubbing firmly along the track so no debris remains.

If necessary, the track can be washed in warm water, wiped

gently and then dried thoroughly using a dry cloth. When

dry, wipe with a lint free cloth and check for marks along the

track. (Note: Lint-free clothes are recommended to avoid dust

or fibers from being deposited). If the track appears worn, or

if cleaning does not improve operation, replacement may be

necessary.

4. Examine the centre channel of the fader body and if dirty,

clean using cotton buds.

5. Re-assemble and lubricate the fader as follows:

a) Hold the fader body so the end block is to your right, as

shown below (the label may be on either side).

a) Insert the slider assembly onto the guide rod and into the

fader body, with the contacts facing away from you.

b) Insert the track into the back of the fader body with the

track contacts facing you (to meet the slider contacts).

c) Lubricate the guide rod by placing one small drop of silicon

oil, using a cocktail stick, either side of the slider assembly.

Move the slider from end to end in order to disperse the oil

evenly. Carefully wipe away any excess oil using a tissue or

cloth.

e) Insert the dust cover and damping washer. Hold in place

while securing the remaining end block. Be sure track wires

exit the bottom of the fader body and are not pinched.

6. Once assembled, move the slider from end to end and ensure

operation is smooth.

Part 13264