Yamaha SP2060 V1.2 Owner's Manual

& Ground Screw
For maximum safety be sure to securely connect the SP2060 
ground screw to an earth connection.
The supplied power cable has a three-prong plug that will 
ground the unit when plugged into an appropriately ground-
ed three-prong type AC mains outlet. If the AC outlet is not 
grounded, be sure to ground the unit by using this ground 
screw.
Correct grounding will effectively eliminate hum noise and 
interference.

* [AC IN] Connector
Connect to the AC mains using the supplied AC power cord.
First connect the power cord to the SP2060, then insert the 
power cord plug into an AC outlet.

( [NETWORK] Connector
This is a 100Base-TX/10Base-T Ethernet connector for con-
nection to a computer or other device in the network.

º [DIGITAL INPUT] Connector (AES/EBU)
Connect an output of an AES/EBU (digital signal) compat-
ible device to this XLR-3-31 connector.

¡ [OUTPUT] Connectors
These XLR-3-32 balanced connectors output six channel an-
alog audio signals. Connect them to the inputs on amplifiers.

™ [INPUT] Connectors
These XLR-3-31 balanced connectors input two channel an-
alog audio signals.

• Use a STP (Shielded Twisted Pair) cable for this connection to 

prevent electromagnetic interference. Since the SP2060 
supports Auto MDI/MDI-X, it will automatically detect 
whether the connected cable is of the straight type or crossover 
type, and will configure itself to create the optimal connection. 
Therefore, you can use either a straight or crossover cable.

• The maximum length of a cable between a switching hub and 

the SP2060 is 100 meters. Due to the quality of cables and 
switching hub performance, however, proper operation at the 
maximum length cannot be guaranteed in some cases.