Yamaha DRX-2 User Manual
General information
ii
English
Laser safety
This unit employs a laser.To prevent possible eye injury, only a qualified
service person should remove the cover or attempt to service this device.
service person should remove the cover or attempt to service this device.
CAUTION
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation
exposure.
VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID
EXPOSURE TO BEAM.
than those specified herein may result in hazardous radiation
exposure.
VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID
EXPOSURE TO BEAM.
ATTENTION
L’emploi de commandes, de réglages ou un choix de procédures
différents des spécifications de cette brochure peut entraîner une
exposition à d’éventuelles radiations pouvant être dangereses.
RAYONNEMENT LASER VISIBLE ET INVISIBLE EN CAS
D’OUVERTURE EXPOSITION DANGEREUSE AU FAISCEAU
différents des spécifications de cette brochure peut entraîner une
exposition à d’éventuelles radiations pouvant être dangereses.
RAYONNEMENT LASER VISIBLE ET INVISIBLE EN CAS
D’OUVERTURE EXPOSITION DANGEREUSE AU FAISCEAU
LASER
Type
InGaAlP semiconductor laser (DVD)
AlGaAs semiconductor laser (CD)
AlGaAs semiconductor laser (CD)
Wavelength
660 nm (DVD)
780 nm (CD)
780 nm (CD)
Output Power
20 mW (DVD writing)
(out of objective)
0.8 mW (DVD reading)
0.3 mW (CD reading)
0.3 mW (CD reading)
Beam divergence
82 degrees (DVD)
54 degrees (CD)
54 degrees (CD)
CAUTION:
Visible and invisible laserradiation
when open. Avoid exposure to beam.
CLASS 1
LASER PRODUCT
CAUTION:
Visible and invisible laser radiation
when open. Avoid exposure to beam.
COMPLIANCE INFORMATION STATEMENT
(DECLARATION OF CONFORMITY PROCEDURE)
Responsible Party : Yamaha Electronics Corporation
Address : 6660 Orangethorpe Avenue
Buena Park, CA90620
Telephone : 714-522-9105
Fax : 714-670-0108
Type of Equipment : DVD Recorder
Model Name : DRX-2
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including
Operation is subject to the following conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received including
interference that may cause undesired operation.
See the user manual instructions if interference to radio reception is
suspected.
suspected.
FCC INFORMATION (for US customers)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly
approved by Yamaha may void your authority, granted by the FCC, to use the product.
approved by Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this
product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in
the USA.
the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices.
Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not
result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used
according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance
with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of
interference, which can be determined by turning the product “OFF” and “ON”, please try to eliminate the problem by using one of the following
measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial
type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If
you can not locate the appropriate retailer, please contact Yamaha Electronics Corp., 6600 Orangethorpe Ave. Buena Park, CA90620.
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used
according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance
with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of
interference, which can be determined by turning the product “OFF” and “ON”, please try to eliminate the problem by using one of the following
measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial
type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If
you can not locate the appropriate retailer, please contact Yamaha Electronics Corp., 6600 Orangethorpe Ave. Buena Park, CA90620.
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B
LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS
AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS OF
THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS
AS SET OUT IN THE RADIO INTERFERENCE REGULATIONS OF
THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
CET APPAREIL NUMÉRIQUE N’ÉMET PAS DE BRUITS
RADIOÉLECTRIQUES DÉPASSANT LES LIMITES APPLICABLES
DANS LA RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUES
ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU
CANADA.
RADIOÉLECTRIQUES DÉPASSANT LES LIMITES APPLICABLES
DANS LA RÈGLEMENT SUR LE BROUILLAGE RADIOÉLECTRIQUES
ÉDICTÉ PAR LE MINISTÈRE DES COMMUNICATIONS DU
CANADA.
NOTE TO CABLE TV SYSTEM INSTALLER:
This reminder is provided to call the Cable TV (CATV) system
installer’s attention to Article 820-40 of the NEC (National Electrical
Code) that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.
installer’s attention to Article 820-40 of the NEC (National Electrical
Code) that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding
system of the building, as close to the point of cable entry as practical.