ZyXEL Communications Plumbing Product metrogigabit switch User Manual
Chapter 13 Spanning Tree Protocol
MGS3700-12C User’s Guide
154
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes
on the Switch. Click Configuration in the Advanced Application > Spanning
Tree Protocol.
on the Switch. Click Configuration in the Advanced Application > Spanning
Tree Protocol.
Figure 71 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 27 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
DESCRIPTION
Spanning Tree
Mode
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or
Multiple Spanning Tree. See
Multiple Spanning Tree. See
for
background information on STP.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.