ZyXEL Communications Plumbing Product metrogigabit switch User Manual

Chapter 20 Classifier

MGS3700-12C User’s Guide

To view a summary of the classifier configuration, scroll down to the summary 
table at the bottom of the Classifier screen. To change the settings of a rule, click 
a number in the Index field.

Note: When two rules conflict with each other, a higher layer rule has priority over 

lower layer rule.

Figure 101   Advanced Application > Classifier: Summary Table 

Socket 
Number

Note: You must select either UDP or TCP in the IP Protocol field before 

you configure the socket numbers. 

Select Any to apply the rule to all TCP/UDP protocol port numbers or select 
the second option and enter a TCP/UDP protocol port number. Refer to 

Destination
IP 
Address/
Address 
Prefix

Enter a destination IP address in dotted decimal notation. 

Specify the address prefix by entering the number of ones in the subnet mask. 

Socket 
Number

Note: You must select either UDP or TCP in the IP Protocol field before 

you configure the socket numbers.

Select Any to apply the rule to all TCP/UDP protocol port numbers or select 
the second option and enter a TCP/UDP protocol port number. Refer to 

Add

Click Add to insert the entry in the summary table below and save your 
changes to the Switch’s run-time memory. The Switch loses these changes if it 
is turned off or loses power, so use the Save link on the top navigation panel 
to save your changes to the non-volatile memory when you are done 
configuring.

Cancel

Click Cancel to reset the fields back to your previous configuration.

Clear

Click Clear to set the above fields back to the factory defaults.

Table 52   Advanced Application > Classifier  (continued)