ZyXEL Communications Plumbing Product metrogigabit switch User Manual
Chapter 36 Differentiated Services
MGS3700-12C User’s Guide
348
36.4.1 Configuring DSCP Settings
To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the
DiffServ screen to display the screen as shown next.
DiffServ screen to display the screen as shown next.
Figure 176 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 117 IP Application > DiffServ > DSCP Setting
LABEL
DESCRIPTION
0 … 63
This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-
down list box.
down list box.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.