ZyXEL Communications Plumbing Product metrogigabit switch User Manual

Page of 448
Chapter 38 Maintenance
MGS3700-12C User’s Guide
360
38.2  Load Factory Default 
Follow the steps below to reset the Switch back to the factory defaults. 
1
In the Maintenance screen, click the Click Here button next to Load Factory 
Default
 to clear all Switch configuration information you configured and return to 
the factory defaults. 
2
 Click OK to reset all Switch configurations to the factory defaults.
Figure 185   Load Factory Default: Start 
3
In the web configurator, click the Save button in the top of the screen to make the 
changes take effect. If you want to access the Switch web configurator again, you 
may need to change the IP address of your computer to be in the same subnet as 
that of the default Switch IP address (192.168.1.1).
38.3  Save Configuration 
Click Config 1 to save the current configuration settings permanently to 
Configuration 1 on the Switch.  
Click Config 2 to save the current configuration settings to Configuration 2 on 
the Switch.
Save 
Configuration
Click Config 1 to save the current configuration settings to 
Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings to 
Configuration 2 on the Switch.
Reboot 
System
Click Config 1 to reboot the system and load Configuration 1 on the 
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the 
Switch.
Note: Make sure to click the Save button in any screen to save your 
settings to the current configuration on the Switch.
Table 122   Management > Maintenance  (continued)
LABEL
DESCRIPTION