ZyXEL Communications Food Warmer vantage access User Manual

 Chapter 8 Device Manipulation

Vantage Access User’s Guide

4 If you want to import devices whose serial numbers are not entirely consecutive, enter a 

value in the Step field. For example, if you want to skip every second serial number, 
enter 2.

5 Click Import. 
6 View the Device List panel to verify the device is registered to Vantage Access 

successfully. 

When the file import is successful, you should see the new entry or entries in the Device List 
panel. 

If you cannot see the new entry or entries, or the registered icon (

) does not display, 

check the system logs and make sure the XML or CSV file format is correct. 

Figure 41   Device Import > Verify in Device List 

After you have uploaded the XML file for a device to the Vantage Access, you must then 
configure the device to allow remote management from the Vantage Access. This 
communication protocol is known as TR-069. Refer to the user’s guide that comes with your 
device for more information.

The following describes the steps to configure settings on a ZyXEL device. Steps may vary 
depending on your device. Refer to the documentation that comes with your device. 

1 To activate TR-069 on the ZyXEL device, access the CLI and enter the following 

commands.

wan tr load

Enable TR-069 configuration. 

wan tr active 1

Activate TR-069 remote management. 

wan tr acsUrl 

172.25.21.174/TR069

Sets the IP address of the Vantage Access server. For example, 
172.25.21.174.

wan tr periodicEnable 1

Enable periodic information update to the server. 

wan tr informInterval 30

Set the information update time. For example, 30 seconds.

wan tr debug on

Enable TR-069 debug mode to view logs.