ZyXEL Communications Food Warmer vantage access User Manual

Chapter 16 General Device Setup

Vantage Access User’s Guide

Figure 141   TR-098: Layer3 Forwarding Table: Details  

The following table describes the labels in this screen. Refer to 

 for 

other field descriptions. 

Table 73   TR-098: Layer3 Forwarding: Forwarding 

Enable

This field displays 1 to indicate that entry in the forwarding table is enabled. 
A value of 0 means that the rule is disabled. This is the default setting for new 
forwarding entries. 

Status

This field displays the status of the forwarding entry. 

Type

This field displays the route type. 
Default sets the device to route packets with any destination. 
Host sets the device to route packets to a specific destination IP address. 
Network sets the device to route packets to an IP network. 

DestIPAddress

This field displays the destination IP address in dotted decimal notation for the 
route entry. 

DestSubnetMask

This field displays the destination subnet mask in dotted decimal notation for 
the route entry.

SourceIPAddress

This field displays the source IP address in dotted decimal notation for the route 
entry.

SourceSubnetMask

This field displays the source subnet mask in dotted decimal notation for the 
route entry.

ForwardingPolicy

This field displays the index number of the forwarding policy the device is to 
use.

GatewayIPAddress

This field displays the IP address of the gateway in dotted decimal notation for 
the route entry. 

Interface

This field displays the hierarchical name of the WAN interface associated to this 
route entry. For example, “InternetGatewayDevice.WANDevice.1.-
WANConnectionDevice.1.WANPPPConnection.1” 

ForwardingMetric

This field displays the number of hops to the destination. This is associated to 
the cost of the route.  
-1 means this route is not used to forward traffic. 

MTU

This field displays the maximum Ethernet packet size allowed on this route.