Zoom A2.1U User Manual

Page of 43
 
ZOOM A2.1u
 
10
 
Using the Tuner 
A 8
B P
M T
Switch to bypass or mute
Setting the A2.1u to the bypass condition
In play mode (or manual mode), press 
both [
W]/[Q] foot switches together 
briefly and release. 
Setting the A2.1u to the mute condition
In play mode (or manual mode), press 
both  [
W]/[Q] foot switches together 
and hold for at least 1 second. 
When you press both [
W]/[Q] foot switches together while 
playing your instrument, the bypass/mute condition is 
activated. However, the sound may change momentarily 
just before the condition is activated. This is because the 
A2.1u switches to the next higher or lower patch when one 
of the foot switches is pressed slightly earlier. (When you 
cancel the bypass/mute condition, the original patch 
number will be active again.) 
This kind of behavior is not a defect. It is due to the very 
high speed at which the A2.1u responds to patch 
switching. To prevent the sound change caused by the 
above condition, do not produce sound with your 
instrument until the bypass/mute condition is fully 
established.
Play the string to tune
Play the open string to tune, 
and adjust the pitch.
The left side of the display shows the 
note which is closest to the current pitch.
Patch change at bypass/mute
 
The A2.1u incorporates an auto-chromatic tuner. To use the tuner function, the built-in effects must be
bypassed (temporarily turned off) or muted (original sound and effect sound turned off). 
eA21u.fm 10 ページ 2005年11月4日 金曜日 午後5時23分