VXi Computer Hardware VX1410A User Manual
Appendix B: Special Configuration Options
B–4
VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual
Enhanced Monitor Board Jumpers
The Enhanced Monitor board has two jumpers accessible from the rear of the
mainframe. Figure B–3 shows the factory default settings of these jumpers.
mainframe. Figure B–3 shows the factory default settings of these jumpers.
+5V Standby sourced from
monitor backup power supply
(default)
monitor backup power supply
(default)
+5V Standby sourced
from P9, pins 8 & 21
from P9, pins 8 & 21
MODID12
(default)
(default)
MODID01
Figure B–3: Enhanced monitor board jumpers
You can also select the source of the +5 V Standby voltage. If you source the
+5 V Standby voltage from the +5 V external supply (Monitor Backup Power
Supply connector), then the external supply will provide the backplane with the
+5 V external voltage (1 A maximum). If you source the +5 V Standby voltage
from the 25-pin connector, you must provide the +5 V to pins 8 and 21 of the
25-pin connector. The default jumper setting is to provide the voltage from the
external source (+5 V external power supply).
+5 V Standby voltage from the +5 V external supply (Monitor Backup Power
Supply connector), then the external supply will provide the backplane with the
+5 V external voltage (1 A maximum). If you source the +5 V Standby voltage
from the 25-pin connector, you must provide the +5 V to pins 8 and 21 of the
25-pin connector. The default jumper setting is to provide the voltage from the
external source (+5 V external power supply).
The Enhanced Monitor can answer to the slot 1 or slot 12 MODID line for the
VXI configuration manager. The default position is slot 12 since it is most likely
to be empty. Slot 1 is available if you use a 2 slot embedded controller.
VXI configuration manager. The default position is slot 12 since it is most likely
to be empty. Slot 1 is available if you use a 2 slot embedded controller.