Vizualogic 2003 User Manual
Care and Maintenance
Your Vizualogic
®
System is a product of superior design and craftsmanship
and should be treated with care. The suggestions below will help to fulfill any
warranty obligations and provide many years of enjoyment.
warranty obligations and provide many years of enjoyment.
• Cleaning the Monitor Screen and Housing: The components may be cleaned
by occasional gentle wiping with a soft, lint-free, cotton cloth that has been
slightly dampened with water.
slightly dampened with water.
CAUTION: Do not use liquids, abrasives, aerosol cleaners, or paper
cleaning products because they will result in permanent damage to the
finish of your components! The LCD screen is made of a specially coated
glass and can be scratched or damaged by abrasive or ammonia-based
window cleaners.
finish of your components! The LCD screen is made of a specially coated
glass and can be scratched or damaged by abrasive or ammonia-based
window cleaners.
• Use and Storage:
- These units contain precision electronics that must be protected from dust,
dirt, and moisture.
- Never spill liquids on any of the components. Liquids, humidity, and
precipitation contain minerals that will corrode electronic circuits.
• Take care to avoid the following:
- Rough handling can break internal circuit boards. Do not drop, knock, or
shake the components.
- Do not attempt to paint or refinish the components. Paint can clog moving
parts and prevent proper operation.
- The components can be damaged by non-expert handling. Attempting to
open any of the components may void the limited warranty.
6
7
Troubleshooting
• No Display: (Screen is blank)
- Point remote control at screen and press “POWER” button.
- Verify 12V power is correctly supplied to Video Controller.
- Verify that monitor cable is connected to Video Controller.
- Verify that 12V circuit is on (i.e., ignition position).
- Verify 12V power is correctly supplied to Video Controller.
- Verify that monitor cable is connected to Video Controller.
- Verify that 12V circuit is on (i.e., ignition position).
• No Video: (Blue screen)
- Make sure all video cables are connected correctly.
- Make sure Source (DVD player, etc…) is “ON.”
- Make sure Source (DVD player, etc…) is in “PLAY” mode.
- Press TV/AV button to ensure correct Input is selected.
- Make sure Source (DVD player, etc…) is “ON.”
- Make sure Source (DVD player, etc…) is in “PLAY” mode.
- Press TV/AV button to ensure correct Input is selected.