Valco electronic Valve Oven User Manual

Chapter 2

Installing Valves in the Heated Oven

Installing valves consists of the following steps:

Step 1.  Installing the solenoid

Step 2.  Disassembling the valve and actuator

Step 3.  Installing the valve and standoff

Step 4.  Connecting gas lines from the solenoid to the actuator

Step 5.  Installing the actuator to the valve standoff

Step 6.  Testing the valve

1. Locate the solenoid manifold in the rear floor of the valve compartment 

(Figure  2-1). The space closest to the rear of the GC is reserved for 
pneumatic valve 1, next is valve two, and so on. 

 

A total of 6 pneumatic valves can be installed (up to 4 in the upper 
compartment and up to 2 in the lower).

2. Remove the rectangular shaped cap from the manifold using the #0 phillips 

screwdriver.

3. Secure the solenoid valve to the underplate using the two screws supplied 

with the valve.