UTStarcom UT-300R2 User Manual
26
Chapter 4 Web-based Management
3
Select the
Encapsulation
type (LLC or VcMux) radio
button that corresponds to the encapsulation in use by
your ISP
your ISP
4
Enter the IP Address, Subnet Mask, and Default Gateway
address as supplied by your ISP.
address as supplied by your ISP.
5
When you are satisfied that all the WAN settings are
configured correctly, click on the
configured correctly, click on the
Apply
button.
6
The new settings must be saved and the UT-300R2 must
be restarted for the settings to go into effect. To manually
save and reboot the UT-300R2, click on the
be restarted for the settings to go into effect. To manually
save and reboot the UT-300R2, click on the
Tools
directory tab and then click the
System
menu button. On
the menu that appears, click he
Save & Restart
button.
The UT-300R2 will save the new settings and restart.
Upon restarting the UT-300R2 will automatically establish
the bridged WAN connection.
Upon restarting the UT-300R2 will automatically establish
the bridged WAN connection.
Note: Some accounts use PPP connection software for their
Internet service connection. If you have been given a CD with
PPP connection software, install this now as instructed by your
service provider. After the UT-300R2 has rebooted it will
negotiate the ADSL connection. Use the connection software to
log on to the ISP network and access the Internet.
PPP connection software, install this now as instructed by your
service provider. After the UT-300R2 has rebooted it will
negotiate the ADSL connection. Use the connection software to
log on to the ISP network and access the Internet.
Configuring a PPP Connection for the WAN
Most ADSL accounts will use either the Point-to-Point Protocol
over Ethernet (PPPoE) or the Point-to-Point Protocol over ATM
(PPPoA) connection. Follow the instructions below to configure
the UT-300R2 to use a PPPoE or PPPoA for the Internet
connection. Make sure you have all the necessary information
over Ethernet (PPPoE) or the Point-to-Point Protocol over ATM
(PPPoA) connection. Follow the instructions below to configure
the UT-300R2 to use a PPPoE or PPPoA for the Internet
connection. Make sure you have all the necessary information