Unisys EFP9800 Series User Manual
Operating the Printer
3255 4073–002
2–3
Changing Receipt Paper
Note: Use these instructions if you are printing receipts only. If you are
printing both receipts and a journal (record of transactions), or a
journal only, see “Changing Receipt/Journal Paper” later in this
section.
journal only, see “Changing Receipt/Journal Paper” later in this
section.
Note: All EFP9800 Series printers have a receipt journal take up spool
assembly factory installed that is not always required or utilized by
the client.
the client.
If the receipt take up assembly is not used, an occasional noise will
occur as the take up roller assembly rotates.
occur as the take up roller assembly rotates.
The receipt take up spool has a spring-loaded roller that allows easy
loading. However, if the receipt take up capability is not being used
the spring loaded roller shaft will spring upwards and hit the printer
top cover once per revolution.
loading. However, if the receipt take up capability is not being used
the spring loaded roller shaft will spring upwards and hit the printer
top cover once per revolution.
In cases where the receipt take up assembly is not being used it can
be secured in a closed position so that it will not hit the top cover
during printing to eliminate the occasional nuisance noise.
be secured in a closed position so that it will not hit the top cover
during printing to eliminate the occasional nuisance noise.
A small piece of tape or a rubber band can be used to keep the take up
roller assembly in a closed position at all times.
roller assembly in a closed position at all times.