X-Micro XWL-11GRTX User Manual

 

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and used in accordance 

with the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures: 

 

-Reorient or relocate the receiving antenna. 

-Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

 

1) this device may not cause interference and 

2) this device must accept any interference, including interference that may cause undesired 

operation of the device. 

 

FCC RF Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. End users must follow the specific operating instructions for satisfying RF 

exposure compliance. This device must not be co-located or operating in conjunction with 

any other antenna or transmitter.   

 

Your device contains a low power transmitter. When device is transmitted it sends out Radio 

Frequency (RF) signal. In order to maintain compliance with the FCC RF exposure guidelines, 

this equipment should be installed and operated with minimum distance 20cm between the 

radiator and your body. 

Use only with supplied antenna. Unauthorized antenna, modification, or attachments could 

damage the transmitter and may violate FCC regulations. 

 

X-Micro declares that US model of XWL-11GRTX, (FCC ID: RAFRTX) is limited in CH 1~ CH 

11 for 2.4G band by specific firmware controlled by the manufacturer and is not user 

changeable.