Symmetricom 1000 User Manual

Chapter 3 Installing the TimeProvider
Unpacking the Unit

 TimeProvider User’s Guide

The TimeProvider and accessories are packaged to protect from normal shock, 
vibration, and handling damage.

Unpack and inspect the unit as follows:

1. Wear a properly grounded protective wrist strap or other ESD device.

2. Inspect the container for signs of damage. If the container appears to be 

damaged, notify both the carrier and your Symmetricom distributor. Retain the 
shipping container and packing material for the carrier to inspect.

3. Open the container, being careful to cut only the packaging tape.

4. Locate and set aside the printed information and paperwork that is included in 

the container.

5. Remove the unit from the container and place it on an anti-static surface.

6. Locate and set aside small parts which may be packed in the container.

7. Remove the accessories from the container. 

8. Remove the anti-static packaging from the unit and accessories.

9. Verify that the model and item number shown on the shipping list agrees with the 

model and item number on the equipment. The item number can be found on a 
label affixed to the TimeProvider. Contact your Symmetricom distributor if the 
model or item number do not match.

For a complete listing of TimeProvider item numbers and configuration options, 
contact your Symmetricom distributor.

The installation procedure described in this section provides general guidelines for 
installing the shelf and the optional Expansion panel and Cable Management tray. 
Always follow applicable local electrical codes.

Main Shelf
The main shelf (Model 1000 and 1100) mounts to either a 19-inch or 23-inch rack 
using reversible mounting ears. 

Caution: To avoid electrostatic discharge (ESD) damage to parts 
that are packaged with the TimeProvider, observe the following 
procedures.