Manualsbrain.com
  1. Manuals
  2. Brands
  3. Symmetricom
  4. 1000
  5. User Manual

Symmetricom 1000 User Manual

Download
Page of 224
097-58001-02 Revision G – April 2008
TimeProvider User’s Guide
81
Chapter 3 Installing the TimeProvider
Installing Connections to the Ethernet Port
Network Connection
You can use a network connection for routine monitoring and control of the 
TimeProvider from a remote site. Perform the following steps to connect the 
TimeProvider to a network. 
1. Connect one end of an RJ-45 cable to the LAN outlet. Connect the other end of 
the cable to the LAN connector on the TimeProvider.
2. To connect the PC or laptop to the LAN, connect one end of the RJ-45 cable to 
the Ethernet port of the PC or laptop. Connect the other end of the cable to the 
LAN outlet.
3. Use a remote monitoring software application such as SynCraft or TimePictra to 
connect to and monitor the TimeProvider. See 
, for more information on installing and using SynCraft.
 lists the Ethernet communications port signal connections.
Table 3-8.  Ethernet Communications Port Signal Connections
Name
Pin
TX+ (Positive Side of Transmitted Data)
1
TX- (Negative Side of Transmitted Data)
2
RX+ (Positive Side of Received Data)
3
Not Used
4
Not Used
5
RX- (Negative Side of Received Data)
6
Not Used
7
Not Used
8