Smarthome SUPERVISED WIRELESS SECURITY CONSOLE PS561 User Manual

This procedure initializes each Re-

mote Control so that the Console rec-

ognizes its commands.

HT544  Remote Control

1.

2.

3.

Install a 9V alkaline  battery in the
HT544’s  battery compartment.

Set the Console to INSTALL.

Press [ARM] on the HT544.

The Console emits a tone. If you do
not hear a tone, press the HT544’s

[CODE] button with a pencil.

Then, repeat this step.

To set up additional HT544s (up to

eight), repeat steps l-3.

Note: when you set the Console back
to RUN it plays back the stored mes-
sage and the BUSY light stays on for

15 seconds.

6

 

HT544

KF574 Key Chain Remote Control

1.

2.

3.

4.

Install a 6V alkaline battery inside
the KF574. Use Eveready A544,

Radio Shack 23-469,  or equivalent.

Set the Console’s slide switch to

INSTALL.

Press [ARM] on the KF574.

The Console emits a tone. If you do

not hear a tone, press the KF574’s

[CODE] button with a pencil.

Then, repeat this step.

To set up additional KF574s  (up to
eight), repeat steps l-3.

When you set the Console back to

RUN it plays back the stored message

and the BUSY light stays on for 15
seconds.

Note: you can install any combination

of Remote Control types (HT544,

KF574 or SH624) up to a total of eight

Remote Controls. For example: you

could install two HT544s.  two SH624s

and four KF574s.  or any other combi-
nation up to a total of eight Remote

Controls.