Smeg WO-01 User Manual

Press ENTER or F1:
Stop motore se in moto per … (Stop motor after …)
The following two messages concern the osmosis pump
motor condition. Set = 0 to exclude this mode; if the value
is not 0, the motor stops running after having run
continuously for the set period, then starts again.

After two seconds, the system displays:>>>>>>>>>>>>>>

Press ENTER or F1:
If the conductivity value remains below set value, no alarm
trips, otherwise an alarm displays.>>>>>>>>>>>>>>>>>>>

Press ENTER or F1:
Set number of pulses per litre for the product flow
meter.>>>>>>>>>>>>>>>>>>>>>>>>>>

Press ENTER or F1:
Set number of pulses per litre for the waste flow
meter.>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Press ENTER or F1:
Set minimum production below which a fault is
reported.>>>>>>>>>>>>>>>>>>>>>>>>>>>>