SmartBridges sB3021 User Manual

 

 

 

Page 50 of 113 

 

i n t e l l i g e n t     w i r e l e s s     p l a t f o r m

 

airHaul

2

 Nexus PRO™ User Guide

 

 

128 

 0-255 

The preference that STP gives to 
this port relative to the other ports 
for forwarding traffic out of the 
spanning tree. 
 
A higher numerical value means 
a lower priority; thus, the highest 
priority is 8. 
 

 

The Radio and Ethernet interfaces are assigned to bridge group by default. When the user enables 
STP and assigns a priority on bridge, STP is enabled on the radio and Ethernet interfaces. The 
interfaces adopt the priority assigned to bridge.  
The user can edit the STP Priority, Bridge Max age, Bridge hello time, Forward Delay, STP Port 
priority and STP Port Path cost. 
 
The  Transparent Aging Time determines the time to refresh entries in the Forwarding Table. The 
Transparent Aging Time default value is 300 seconds.  
 

Follow the steps below to configure the bridge STP in Root Bridge or Remote Bridge: 

 

1. Click 

on 

Networking | Bridge Configuration to access the Bridge Configuration page. 

 
2. Choose 

Enable from the Spanning Tree Protocol pull down list. 

 

3.  Click on the Generic Bridge Port Table link to change the Generic Parameters. 

 

4.  Enter a value for the STP Priority. 

 

5.  Enter values for the Bridge Max Age, Bridge Hello Time and Bridge Forward Delay 

 

6. Click 

on 

Transparent Aging Time link to change the Transparent Aging Time. 

 

7.  Click on the Spanning Tree Port Table link to change the ’STP Ethernet Port’ parameters. 

 

8.  Enter the values of Ethernet Port Priority and/or Port Path Cost for ETH A 

 

9.  Enter the values of Ethernet Port Priority and/or Port Path Cost for ETH B 

10.  Enter the values of Ethernet Port Priority and/or Port Path Cost for Radio A 

11. Click on Apply Changes Button to save to the current configuration file.