SMART Technologies Hub VE220 User Manual
22 |
CHAPTER 2 – CONFIGURING YOUR HUB
System Information Commands
Connecting to Computers and Video
Sources
Sources
IMPORTANT
This section applies to the SMART Hub SE240 only.
This section applies to the SMART Hub SE240 only.
You can connect your hub to up to two computers and two video sources.
After connecting your hub to a computer or video source, you can view the computer
or video source’s input on your SMART product’s interactive screen.
or video source’s input on your SMART product’s interactive screen.
NOTE
You can connect a computer with SMART Notebook™ software version 9.7 SP1
or later to your hub and use the digital ink features of the software. Your hub
doesn’t support earlier versions of SMART Notebook.
You can connect a computer with SMART Notebook™ software version 9.7 SP1
or later to your hub and use the digital ink features of the software. Your hub
doesn’t support earlier versions of SMART Notebook.
To view a connected
computer’s input
Press one of the computer input buttons on the sidebar.
The computer’s input appears.
NOTE
The default label of the first DVI input button is Computer One, and the default
label of the second DVI input button is Computer Two. You can change
these labels.
The default label of the first DVI input button is Computer One, and the default
label of the second DVI input button is Computer Two. You can change
these labels.
Command
Description
get lamphrs
Requests the number of hours that the projector
lamp has been in use (from 0 to 3000).
lamp has been in use (from 0 to 3000).
NOTE
This command only returns a value if the
SMART Hub SE240 is connected to a UF, UX
or Unifi projector.
This command only returns a value if the
SMART Hub SE240 is connected to a UF, UX
or Unifi projector.
get syshrs
Requests the number of hours that the system has
been in use.
been in use.
get ipaddr
Requests the IP address.
get macaddr
Requests the MAC address.
get fwver
Requests the firmware version.